Computer Science, asked by snarang114, 5 months ago

14. which command is used to
display data on the output screen
O F5
O FZ
O F9​

Answers

Answered by keyboardavro
1

Answer:

F5

Explanation:

In QBasic you can run a program in a number of ways. The easiest method is by pressing F5. Do that now. You will find that the screen clears to black and prints the word "Hello World" in the top left corner.

Previous Question
Next Question
Similar questions
English, 2 months ago
what made kara go to see her father? in the white dolphin​...
English, 2 months ago
write a note on the depletion of fossil fuels-its causes and effects? (Word limit: 200 words) Don't answer unnecessarily, I'll report as well as file a complaint against you in the brainly office. Well wishers are gladly invited to answer. I already googled but can't find relevant answers. so don't suggest me this. ​
Math, 2 months ago
there are two types of bags which contains 4 more balls than 8 times the number of balls in smaller bag. the total number of balls in larger bag is find the number of balls contained in smaller bag​...
Social Sciences, 5 months ago
Which one of the following is not a cause of urban unemployment ? * a.Mass migration from rural to urban areas b .slow rate of economic development c.Maladjustment between the demand and supply of labour d.caste system​...
Hindi, 5 months ago
65 हम होंगे कामयाब कामयाब शीर्षक kaisae laga​...
Biology, 9 months ago
increase in pH will shifts O2 dissociation curve towards_​...
Computer Science, 9 months ago
Excel displays current cell address in the _...
Math, 9 months ago
A ladder 25 m long reaches a window at a height of 7 m above the ground. Keeping its foot at the same point, the ladder is turned so that it reaches a window 20 m high across the street. Find the total width of the street.​