Question

6.What is meant by electrical resistivity of a material? Derive its S.I. unit. Describe an experiment to study the factor on which the resistance of a conducting wire depends. answer correctly or else i'll report!​

Answer 1

Answer:

cross sectional area is 1m²,then resistance of conductor is called resistivity. ... this resistance is called resistivity. resistance of a conductor depends on dimensions of the conductor(volume ,length,area).

Answer 2

Answer:-

Electrical Resistivity:-

Resistivity, electrical resistance of a conductor of unit cross-sectional area and unit length. A characteristic property of each material, resistivity is useful in comparing various materials on the basis of their ability to conduct electric currents.

SI unit:-

The SI unit of electrical resistivity is the ohm-meter (Ω⋅m). For example, if a 1 m solid cube of material has sheet contacts on two opposite faces, and the resistance between these contacts is 1 Ω, then the resistivity of the material is 1 Ω⋅m.

Experiment:-

Experiment to check on which factor resistance depends:

Consider an electric circuit consisting of a cell, an ammeter, a nichrome wire of length L(marked 1 to 4) and a plug key as shown in figure.

Now plug the key and note the current ammeter. 

Replace the nichrome wire by another nichrome wire of same thickness but twice the length that is 2l at point 2. 

Again note the reading. 

Now, replace the wire by a thicker nichrome wire of same length (marked 3). A thicker wire has a larger cross-sectional area. 

Again note down the current through the circuit. 

Replace nichrome wire with copper wire of same length and same area of cross-section at point 4, 

Note the value of current. 

Notice the difference in the current in all cases. When the length of the wire is doubled, 

then the ammeter reading decreases to half its previous value i.e., current through the wire is halved.

 Since, resistance of the wire , then R is doubled which implies R×L. 

When the nichrome wire is replaced by a thicker one of same material and length, the current in the wire increases which means that the resistance of the thicker wire (3) is less than that of the thinner wire (1). 

This implies .  When the nichrome wire is replaced by a copper wire (4) of the same length and same cross-sectional area, then the current recorded by the ammeter is more. 

This means that the resistance of copper wire is less than that of the nichrome wire of the same dimensions i.e. ,the resistance of the wire depends on the nature of its material.

Itz a bit lengthy exp..U can just cut short it..