a circle of 50mm diameter,rolls on the inner side of another circle of 50mm radius.draw the path traced by a point on the rolling circle for one complete revolution .
Answers
Answer:
Given Data:- Diameter of rolling circle Φ = 50 mm
Normal and tangent point = 30 mm above straight line.
Assumption – Circle is rolling towards right side (Show the direction)
Procedure:-
1) Draw a circle of 50 mm diameter.
2) Draw horizontal and vertical axis and mark centre of the circle say C
3) Divide the circle into 12 equal parts and name each division 1, 2, 3, ….12 as per shown in fig.
4) Draw a straight horizontal line of length πD from point P at the contact surface of circle and ground . 5) Divide the line into 12 equal parts 1’, 2’, 3’…..12’ (same no. as that of circle).
6) Draw again a circle of 50 mm diameter at πD distance with centre C’.
7) Draw horizontal and vertical axis for 2nd circle.
8) Draw horizontal lines from points (1,11) (2,10) (3,9) (4,8) (5,7) and 6 up to vertical axis of 2nd circle .
9) Draw vertical lines from point 1’, 2’, 3’,…. 12’ up to horizontal axis and name it C1, C2, C3….C12 respectively.
10) Taking C1 as centre and 25 mm radius (radius of rolling circle) cut the horizontal line passing through point on the circle near point P. Mark that point P1.
11) Repeat the same procedure up to C12 and accordingly marks points up to P12.
12) Draw smooth curve passing through all 12 points (P1, P2, ….. P12) and name the curve.
13) Mark a point M on the curve at a distance of 30 mm from horizontal line.
14) Taking M as centre and 25 mm radius (radius of rolling circle) cut the horizontal axis and mark that point Q.
15) Draw perpendicular from Q on horizontal and mark it as N.
16) Draw a line passing through M and N (NMN is normal).
17) Draw a line perpendicular to normal from point M (TMT is required tangent)
Step-by-step explanation:
RADHE RADHE ❤