Math, asked by amruta168, 3 months ago

Ashu takes 12 days to complete the work. Pranav takes 10 days to complete the same
work. Ashu, Pranav and Ramu take 5 days to complete the same work. How many days
will Ramu take to complete the same work?

Answers

Answered by mamta968

7

The work has already been done... XD

Attachments:

Answered by shubhangisax8081

5

Answer:

Work done by Ashu in one day = 1/12

Work done by Pranav in one day = 1/10

Work done by Ashu,Pranav and Ramu in one day = 1/5

Work done by Ashu and Pranav in one day= 1/12 + 1/10

= (6+5)/60 = 11/60

Work done by Ramu in one day = 1/5 - 1160

(12-11)/60 = 1/60..

Work done by ramu = 60

Therefore Ramu would take 60 days..

Hope it helps

Pls mark my answer as brainliest..

Previous Question

Next Question

Similar questions

English, 1 month ago

passive voice the following sentence. we saw an army of ants. A)= An army of ants was seen by us. B)= An army of ants were seen by us. C)= An army of ants is seen by us.

Geography, 1 month ago

state with the reason it it would be feasible to set up an iron and steel industry in your district...

Science, 1 month ago

Define adolescence. Write any three changes that occur during adolescence.

Math, 3 months ago

the value of x in 2× x2²=2⁹ is ___________...

Science, 3 months ago

. Why do we usually see less stars on a full Moon day (when the Moon is seen as a complete circle) than on a new Moon day (when the Moon is not seen)?

Physics, 9 months ago

The gravitational potential in a region is given by, V = 200(X + Y) J//kg. Find the magnitude of the gravitational force on a particle of mass 0.5 kg placed at the orgin.

Physics, 9 months ago

The second's pendulum is taken from earth to moon, to keep time period constant (a) the length of the second's pendulum should be decreased (b) the length of the second's pendulum should be increased ( c) the amplitude should increase (d) the amplitude should decrease.

Physics, 9 months ago

The pitch of a screw gauge having 50 divisions on its circular scale is 1 mm When the two jaws of the screw gauge are in contact with each other, the zero of the circular scale lies 6 divisions below the line of gradution. when a wire is placed between the jaws, 3 linear scale divisions are clearly visible while 31 division on the circular scale coincides with the reference line. Find diameter of...