calculate the mass of magnesium when 5 gram of magnesium oxide and heated
Answers
Answer:
The practical activity takes around 30–45 minutes, depending on the competence of the class. Students should all be standing and should wear eye protection. Students with long hair should tie it back.
It is a good idea for students to practice lifting the lid on and off the crucible and the crucible off the pipe clay triangle before they start. This has the added bonus of checking that all the tongs are functioning correctly.
To enable students to light their Bunsen burners they will need access to matches or lighters. Alternatively, light one or two Bunsen’s around the room and students can light their own using a splint.
The most significant hazard in this experiment is the hot apparatus. Warn students that it will take some time to cool down.
Apparatus
Eye protection.
Access to a balance (2 decimal places)
Per pair or group of students:
Crucible with lid
Tongs
Pipe clay triangle
Bunsen burner
Tripod
Heat resistant mat
Emery paper (optional)
Chemicals
Magnesium ribbon, about 10–15 cm
Health, safety and technical notes
Read our standard health and safety guidance
Wear eye protection.
Magnesium ribbon, Mg(s) – see CLEAPSS Hazcard HC059a. Fresh, clean magnesium is best for this experiment. If the magnesium is tarnished then emery or sand paper will be required to clean it.
Procedure
Cut a piece of magnesium about 10–15 cm long. If it is looking tarnished or black then clean it using the emery paper. Twist it into a loose coil.
Weigh the crucible with the lid (mass 1) and then the magnesium inside the crucible with the lid (mass 2).
Set up the Bunsen burner on the heat resistant mat with the tripod. Place the pipe clay triangle over the tripod in a Star of David formation, ensuring that it is secure. Place the crucible containing the magnesium in the pipe clay triangle and put the lid on.
Light the Bunsen burner and begin to heat the crucible. It is best to start with a gentle blue flame, but you will need to use a roaring flame (with the air hole fully open) to get the reaction to go.
Once the crucible is hot, gently lift the lid with the tongs a little to allow some oxygen to get in. You may see the magnesium begin to flare up. If the lid is off for too long then the magnesium oxide product will begin to escape. Don’t let this happen.
Keep heating and lifting the lid until you see no further reaction. At this point, remove the lid and heat for another couple of minutes. Replace the lid if it appears that you are losing some product.
Turn off the Bunsen burner and allow the apparatus to cool.
Re-weigh the crucible with lid containing the product (mass 3).
Heat the crucible again for a couple of minutes and once again allow to cool. Repeat this step until the mass readings are consistent. This is known as heating to constant mass.
The apparatus and set up required to calculate the change on mass when magnesium burns
Source: RSC
Teaching notes
Students should have recorded the following masses:
mass 1 = crucible + lid
mass 2 = crucible + lid + magnesium
mass 3 = crucible + lid + product
This should allow them to calculate the mass of the mass of the magnesium (mass 2 – mass 1) and the mass of the product (mass 3 – mass 1). They could also calculate the increase in mass (mass 3 – mass 2), which corresponds to the mass of oxygen.
mass of the oxygen. They will also require the relative atomic masses. Magnesium is 24 and oxygen is 16.
They should divide mass by the atomic mass for each element. The gives the number of moles of each.
Having done this for both elements, they should find the ratio between the two by dividing them both by the smallest number.
The ratio should be close to 1:1 as the formula of magnesium oxide is MgO.
Example calculation:
Mass magnesium = 2.39 g
Mass magnesium oxide = 3.78 g
So mass oxygen = 1.39 g
Number moles Mg = 2.39/24 = 0.0995
Number moles O = 1.39/16 = 0.0868
Divide by the smallest to give the ratio aproximately 1 Mg : 1 O
This would suggest a formula of MgO, which is the correct formula
Method two
Explanation:
reaction-2mgo=mg+02
no of mole in 5gram of magnesium oxide =5/40=0.125 mole
from 2 mole of mgo 1 mole of mg is detoxised..
from 0.125 mole of mgo 0.0625 mole formed
0.0625 =x/24
0.0625*24=x
1.5 gm= mass