Computer Science, asked by starkchampak, 6 months ago

_________ command is used to end the loop and transfer the control to the next instruction following the loop. *

Answers

Answered by harshdhawan1037h

1

Answer:

ctrl + loop playback

Explanation:

i am not sure that my answer is correct.

Previous Question

Next Question

Similar questions

Science, 3 months ago

Hello! Define force_?

Math, 3 months ago

In the given figure, ABCD is a square. M is the mid-point of AB and PQ is perpendicular to CM. CB produced meets PQ at point Q. Prove that : (i) PA = BQ (ii) CP = AB + PA. pls answers only, otherwise i will report!!

Math, 3 months ago

twenty years from now i will be 4 times as old as my present age. what is my present age...

Geography, 6 months ago

Anong ibig sabihin ng griyego...

Science, 6 months ago

Example of cereals ________ ( wheat / green gram )...

Physics, 11 months ago

24. Figure gives the speed-time graph of the motion of a car. What is the ratio of the distance travelled by the car during the last two seconds to the total distance travelled in seven seconds? A. 1:9 254 B. 2:9 Speed (ms) - C. 1:3 1 7 D. 4:9 2 3 4 5 6 Time (s)...

English, 11 months ago

they compelled raman to leave the house(passive voice)...

Geography, 11 months ago

diference between globe and map...