CURRENT)
8.(i) During the experiment on
electromagnetic induction, what is
needed to be done to (a) maintain a
steady flow of current(b) stop the
flow of current(c)increase the
strength of induced current.(ii) Write
any two applications of
Elecromagnetic Induction(EMI).
Answers
Answer:
Register to download premium content!
X
DeutschDeutsch PolskiPolski
Register
Log In
AC Circuits
Amplifiers
Attenuators
Binary Numbers
Boolean Algebra
Capacitors
Combinational Logic
Connectivity
Counters
DC Circuits
Diodes
Electromagnetism
Filters
Inductors
Input/Output Devices
Logic Gates
Miscellaneous Circuits
Operational Amplifiers
Oscillator
Power Electronics
Power Supplies
Premium
RC Networks
Resistors
Sequential Logic
Systems
Transformers
Transistors
Waveform Generators
Premium Content
Further Education
Sitemap
Contact Us
Home / Electromagnetism / Electromagnetic Induction
Electromagnetic Induction
When a DC current passes through a long straight conductor a magnetising force and a static magnetic field is developed around it
If the wire is then wound into a coil, the magnetic field is greatly intensified producing a static magnetic field around itself forming the shape of a bar magnet giving a distinct North and South pole.
air cored electromagnetic coil
Air-core Hollow Coil
The magnetic flux developed around the coil being proportional to the amount of current flowing in the coils windings as shown. If additional layers of wire are wound upon the same coil with the same current flowing through them, the static magnetic field strength would be increased.
Therefore, the magnetic field strength of a coil is determined by the ampere turns of the coil. With more turns of wire within the coil, the greater the strength of the static magnetic field around it.
But what if we reversed this idea by disconnecting the electrical current from the coil and instead of a hollow core we placed a bar magnet inside the core of the coil of wire. By moving this bar magnet “in” and “out” of the coil a current would be induced into the coil by the physical movement of the magnetic flux inside it.
Likewise, if we kept the bar magnet stationary and moved the coil back and forth within the magnetic field an electric current would be induced in the coil. Then by either moving the wire or changing the magnetic field we can induce a voltage and current within the coil and this process is known as Electromagnetic Induction and is the basic principle of operation of transformers, motors and generators.
Electromagnetic Induction was first discovered way back in the 1830’s by Michael Faraday. Faraday noticed that when he moved a permanent magnet in and out of a coil or a single loop of wire it induced an ElectroMotive Force or emf, in other words a Voltage, and therefore a current was produced.
So what Michael Faraday discovered was a way of producing an electrical current in a circuit by using only the force of a magnetic field and not batteries. This then lead to a very important law linking electricity with magnetism, Faraday’s Law of Electromagnetic Induction. So how does this work?.
When the magnet shown below is moved “towards” the coil, the pointer or needle of the Galvanometer, which is basically a very sensitive centre zero’ed moving-coil ammeter, will deflect away from its centre position in one direction only. When the magnet stops moving and is held stationary with regards to the coil the needle of the galvanometer returns back to zero as there is no physical movement of the magnetic field.
Likewise, when the magnet is moved “away” from the coil in the other direction, the needle of the galvanometer deflects in the opposite direction with regards to the first indicating a change in polarity. Then by moving the magnet back and forth towards the coil the needle of the galvanometer will deflect left or right, positive or negative, relative to the directional motion of the magnet.
Electromagnetic Induction by a Moving Magnet
electromagnetic induction