(Describe a process about how to paste a puncture in cycle tube ) friends please take it seriously because I am in an urgent. so answer fastly
Answers
Step 1
Clean And Dry the inner tube
If you used water to trace the hole make sure the inner tube is dry. Use fine sandpaper or an emery board to clean the area around the hole. Clean an area larger than the patch you intend to apply.
step 2
Spread The Cement
Smear a thin layer of rubber solution around the hole.
step 3
Wait
The cement is a solution. Don’t apply the patch until all the solvent has evapourated. If you sniff the layer of solvent you must smell only the rubber of the inner tube, not the alcohol solvent. The length of time this takes depends on the weather conditions it’s quicker in warm dry air, longer when it’s cold and wet.
step 4
Rediscover The Hole
If you’re not certain where the hole is pump a small amount of air into the inner tube to show where the air escapes
step 5
Apply The Patch
Peel the protective layer off the patch. If the patch has paper on one side and foil on the other it’s the foil that comes off. If it has paper and cellophane, it’s the paper. Apply the patch to layer of glue so the hole is centred under the patch.
step 6
Bond
Place the inner tube on a firm smooth surface and rub the patch onto the inner tube with a smooth implement. A tyre lever works well. This action encourages the patch to bond to the inner tube
step 7
Remove The Backing
Fold the inner tube to crack the backing paper or cellophane and peel it off from the centre outwards. If you want to leave the backing on that’s no problem. The inner tube will work with it still on.
step 8
Dust
Dust the patch and surrounding area with fine dust or chalk. A patch kit often has a block of chalk to generate this dust but you can use any fine dust lying around. The dust neutralises the glue around the patch so that the inner tube won’t stick to the inside of the tyre.
PRO-TIP
If this is a routine patch – as opposed to an emergency repair – hang the inner tube up overnight with enough air in to hold an ‘O’ shape. If they haven’t sagged to an ‘I’ by morning they are holding air and ready for re-use.
step 9
Roll
Roll the inner tubes carefully to force all the air out then fold with the valve on the inside and secure with a rubber band.
I HOPE IT WILL HELP U
PLZZZ SAY THANKS TO ME AND PLZZZZ FOLLOW ME