difference between design mode and run mode
Answers
Answer:
The VBA IDE can be in any one of three modes: run mode, break mode, or design mode. The IDE is in design mode when you are writing code or designing a form.
Run mode occurs when a procedure is running. To run (or execute) a procedure, just place the cursor anywhere within the procedure code and hit the F5 key (or select Run from the Run menu). If a running procedure seems to be hanging, you can usually stop the procedure by hitting Ctrl-Break (hold down the Control key and hit the Break key).
Break mode is entered when a running procedure stops because of either an error in the code or a deliberate act on your part (described later in this chapter). In particular, if an error occurs, Word will stop execution and display an error dialog box with an error message, an example of which is shown in Figure 4-2.
An error message
Figure 4-2. An error message
Error dialog boxes offer a few options: end the procedure, get help (such as it may be) with the problem, or enter break mode to debug the code. In the latter case, Word will stop execution of the procedure at the offending code and highlight that code in yellow. (I discuss the process of debugging code in the “Debugging” section later in this chapter.)
Aside from encountering an error, there are several ways we can deliberately enter break mode for debugging purposes:
Hit Ctrl-Break and choose Debug from the resulting dialog box.
Include a Stop statement in the code, which causes Word to enter break mode.
Insert a breakpoint on an existing line of executable code. This is done by placing the cursor on that line and hitting the F9 key (or using the Debug menu). Word will place a red dot in the left margin in front of that line and will stop execution when it reaches the line. You may enter more than one breakpoint in a procedure. This is generally preferred to using the Stop statement, because breakpoints are automatically removed when you close down the Visual Basic Editor, so you don’t need to remember to remove them, as you do with Stop statements.