Question

Difference between forward and backward recovery in distributed system

Answer 1

The labels on bottles of commercial reagents often describe the contents in terms of mass percentage. Sulfuric acid, for example, is sold as a 95% aqueous solution, or 95 g of H2SO4H2SO4 per 100 g of solution. Parts per million and parts per billion are used to describe concentrations of highly dilute solutions. These measurements correspond to milligrams and micrograms of solute per kilogram of solution, respectively. For dilute aqueous solutions, this is equal to milligrams and micrograms of solute per liter of solution (assuming a density of 1.0 g/mL).

EXAMPLE 13.4.213.4.2: MOLARITY AND MASS

Several years ago, millions of bottles of mineral water were contaminated with benzene at ppm levels. This incident received a great deal of attention because the lethal concentration of benzene in rats is 3.8 ppm. A 250 mL sample of mineral water has 12.7 ppm of benzene. Because the contaminated mineral water is a very dilute aqueous solution, we can assume that its density is approximately 1.00 g/mL.

What is the molarity of the solution?

What is the mass of benzene in the sample?

Given: volume of sample, solute concentration, and density of solution

Asked for: molarity of solute and mass of solute in 250 mL

Strategy:

Use the concentration of the solute in parts per million to calculate the molarity.

Use the concentration of the solute in parts per million to calculate the mass of the solute in the specified volume of solution.

Solution:

a. A To calculate the molarity of benzene, we need to determine the number of moles of benzene in 1 L of solution. We know that the solution contains 12.7 ppm of benzene. Because 12.7 ppm is equivalent to 12.7 mg/1000 g of solution and the density of the solution is 1.00 g/mL, the solution contains 12.7 mg of benzene per liter (1000 mL). The molarity is therefore

molarity=moleslitersolution=(12.7mg)(1g1000mg)(1mol78.114g)1.00Lmolarity=moleslitersolution=(12.7mg)(1g1000mg)(1mol78.114g)1.00L

=1.63×10−4M=1.63×10−4M

b. B We are given that there are 12.7 mg of benzene per 1000 g of solution, which is equal to 12.7 mg/L of solution. Hence the mass of benzene in 250 mL (250 g) of solution is

massofbenzene=(12.7mgbenzene)(250mL)1000mLmassofbenzene=(12.7mgbenzene)(250mL)1000mL

=3.18mg=3.18×10−3gbenzene=3.18mg=3.18×10−3gbenzene

EXERCISE 13.4.213.4.2: MOLARITY OF LEAD SOLUTION

The maximum allowable concentration of lead in drinking water is 9.0 ppb.

Answer 2

Difference between forward and backward recovery in distributed system  is given below

Explanation:

• In the forward recovery state the if  transaction is failure then it removes the error and continue the process where as in the backward if there is any error is occur then it restarted  that process .
• In the forward recovery as it removes the error and then going forward so it confirms that the error does not happen again where as there is no such conformation in the backward recovery.
• As we going to implementation point of you we can easily implement the backward recovery however the forward recovery is complex to implement .  

Learn More:

• brainly.in/question/9143780