explain following network device surface and modem ( Those will give answer I will like 100
Answers
Answered by
1
A modem (portmanteau of modulator-demodulator) is a hardware device that converts data into a format suitable for a transmission medium so that it can be transmitted from computer to computer (historically over telephone wires). A modem modulates one or more carrier wave signals to encode digital information for transmission and demodulates signals to decode the transmitted information. The goal is to produce a signal that can be transmitted easily and decoded to reproduce the original digital data. Modems can be used with almost any means of transmitting analog signals from light-emitting diodes to radio. A common type of modem is one that turns the digital data of a computer into modulated electrical signal for transmission over telephone lines and demodulated by another modem at the receiver side to recover the digital data.
Modems are generally classified by the maximum amount of data they can send in a given unit of time, usually expressed in bits per second (symbol bit(s), sometimes abbreviated "bps") or bytes per second (symbol B(s)). Modems can also be classified by their symbol rate, measured in baud. The baud unit denotes symbols per second, or the number of times per second the modem sends a new signal. For example, the ITU V.21 standard used audio frequency-shift keying with two possible frequencies, corresponding to two distinct symbols (or one bit per symbol), to carry 300 bits per second using 300 baud. By contrast, the original ITU V.22 standard, which could transmit and receive four distinct symbols (two bits per symbol), transmitted 1,200 bits by sending 600 symbols per second (600 baud) using phase-shift keying
Modems are generally classified by the maximum amount of data they can send in a given unit of time, usually expressed in bits per second (symbol bit(s), sometimes abbreviated "bps") or bytes per second (symbol B(s)). Modems can also be classified by their symbol rate, measured in baud. The baud unit denotes symbols per second, or the number of times per second the modem sends a new signal. For example, the ITU V.21 standard used audio frequency-shift keying with two possible frequencies, corresponding to two distinct symbols (or one bit per symbol), to carry 300 bits per second using 300 baud. By contrast, the original ITU V.22 standard, which could transmit and receive four distinct symbols (two bits per symbol), transmitted 1,200 bits by sending 600 symbols per second (600 baud) using phase-shift keying
Answered by
2
answer..
...
I will give only name.....
repeater.. repeater operator at the physical layer it job is to regenerate the single over the same network before the single become too weak......
hub... hub is basically a multiport repeater ...hub connected multiple wire
hope this is helping you
...
mark me brainlist.... plz
Similar questions