explain how mirror is manufactured
Answers
Answer:
The modern mirror is made by silvering, or spraying a thin layer of silver or aluminum onto the back of a sheet of glass. Justus Von Leibig invented the process in 1835, but most mirrors are made today by heating aluminum in a vacuum, which then bonds to the cooler glass [source: Britannica].
I hope it help you
Answer:
The Manufacturing
Process
Cutting and shaping the glass
1 .
The first step in manufacturing any mirror is cutting the outline of the glass "blank" to suit the application. If the mirror is for an automobile, for example, the glass will be cut out to fit in the mirror mount on the car. Although some mirror manufacturers cut their own glass, others receive glass that has already been cut into blanks. Regardless of who cuts the glass, very hard, finely pointed blades are used to do the cutting. Diamond scribes or saws—sharp metal points or saws with diamond dust embedded in them—are often used because the diamond will wear down the glass before the glass wears down the diamond. The cutting method used depends entirely on the final shape the mirror will take. In one method, the blades or scribes may be used to cut partway through the glass; pressure can then be used to break the glass along the score line. In another method, a machine uses a diamond saw to cut all the way through the glass by drawing the blade back and forth or up and down multiple times, like an automated bandsaw. Cutting is usually done before the metal coating is applied, because the coating may flake off the glass as a result of the cut. An alternative to cutting the glass to form blanks is to moldthe glass in its molten state.
2 .
Blanks are then placed in optical grinding machines. These machines consist of large base plates full of depressions that hold the blanks. The blank-filled base is placed against another metal plate with the desired surface shape: flat, convex, or concave. A grinding compound—a gritty liquid—is spread over the glass blanks as they are rubbed or rolled against the curved surface. The action is similar to grinding spices with a mortar and pestle. The grit in the compound gradually wears away the glass surface until it assumes the same shape as the grinding plate. Finer and finer grits are used until the surface is very smooth and even.
Hand grinding techniques exist as well, but they are extremely time-consuming and difficult to control. They are only used in cases where mechanical grinding would be impossible, as is the case with very large or unusually shaped surfaces. A commercial optical grinder can accommodate 50 to 200 blanks, which are all polished simultaneously. This is much more efficient than hand grinding. Even specialty optics can be made mechanically in adjustable equipment.
HOPE IT HELPS YOU