Question

Explain principle,construction and working of AC generator

Answer 1

Euclid's Postulates

1. A straight line segment can be drawn joining any two points.

2. Any straight line segment can be extended indefinitely in a straight line.

3. Given any straight line segment, a circle can be drawn having the segment as radius and one endpoint as center.

4. All right angles are congruent.

5. If two lines are drawn which intersect a third in such a way that the sum of the inner angles on one side is less than two right angles, then the two lines inevitably must intersect each other on that side if extended far enough. This postulate is equivalent to what is known as the parallel postulate.

Euclid's fifth postulate cannot be proven as a theorem, although this was attempted by many people. Euclid himself used only the first four postulates ("absolute geometry") for the first 28 propositions of the Elements, but was forced to invoke the parallel postulate on the 29th. In 1823, Janos Bolyai and Nicolai Lobachevsky independently realized that entirely self-consistent "non-Euclidean geometries" could be created in which the parallel postulate did not hold. (Gauss had also discovered but suppressed the existence of non-Euclidean geometries.)

Answer 2

$\huge \bf{hey}$



$\huge{ \mathfrak{here \: is \: answer}}$
$\bf{\: principal}$


It is based on the principle of electromagnetic induction . when a coil is rotated about an axis perpendicular to the direction of uniform magnetic field, an indused emf produced across it.


$\bf{construction}$


The AC generator consists of the following parts :

$\sf{1. \: armature}$

A rectangular coil ABCD consisting of a large number of turns wound over a soft iron core is called armature. the soft iron core is used to increase the magnetic flux.

$\sf{2. \: field \: magnet}$

it is a strong magnet having concave poles. the armature is rotated between the two poles of this magnet so that axis of armature is perpendicular to magnetic field lines. in a small AC generator the magnet is the permanent magnet but in Big AC generators it is an electromagnet.

$\sf{3. \: slip \: rings}$


the leads from the arms of armature AC connected to two slip rings S, which rotate with the loop .


$\sf{4. \: brushes}$

the rings slide against stationery contacts called brushes . these brushes are made up of carbon. these brushes are connected to the output terminals p and q.

$\bf{working}$


the working of AC generator can be understood with the help of various positions of the armature .

suppose at time 't' =0 , the plane of the loop is perpendicular to B . as the loop rotate from position t=0 to position t=T/2 , induced EMF changes from zero to maximum value and then becomes zero again, hence induced EMF is zero. as the loop moves from position t =T /2 to position t=T , the EMF again changes from zero to maximum value and then again becomes zero .

Thus the output of the AC generator varries sinusoidally with time . The induced EMF does not depend upon the shape of the loop but depends only upon area of the loop..



$\huge \boxed{ \boxed{ \boxed{hope \: it \: helps}}}$

$\huge{ \mathfrak{thanks}}$