Science, asked by dewalttblhues, 3 months ago

function of datum when marking out the profile of a components​

Answers

Answered by diyabhana
1

Answer:

The datum can be a single point eg the centre of a hole or face of a feature to a component. A datum is used to reduce errors when marking out, and measuring by reducing the accumulation of errors.

Previous Question
Next Question
Similar questions
English, 1 month ago
Q1. True or False. (a) The narrator spotted a roll top desk in Bridport (b) The date on letter was February 25, 1915. (c) Two armies were of Britain and America (d) Tommy was the common name used for English soldiers. (e) The letter was written by Mr Jim Macpherson Q2. Fill in the blanks. (a) The man said it was early nineteenth century, and _________. (b) Inside the box there was an _____​...
English, 1 month ago
Write a article Write an artickle the social networking or video game have completely replaced conventiol out door game...
Hindi, 1 month ago
जिला में संचालित शासकीय योजनाओं का नाम...
Chemistry, 3 months ago
100g of water containing 2g organic compound x is extracted by 50cm3 of ether in (a) one batch(the batches each 25cm3 of ether of 25cm3 of ether assuming that ether and water are immisible and that partition coefficient of x between ether of water is 8 at the.calculate the mass x extracted...
Math, 3 months ago
what is the expanded form of 482,402...
Science, 10 months ago
Mankind is good for ear pain ​...
Math, 10 months ago
What is the degree of polynomial of -3/2...
English, 10 months ago
Nile is the longest river in the world degrees of comparition...