give the names and symbols for common electrical components
Answers
Explanation:
Wire
A wire is used to connect an individual component to another.
Wires Joined
A single device can be linked to another through wires. It is a representation by sketching “blobs” where they are touched or shorted.
Unjoined Wires
It should be known that whenever circuits are sketched some wires may not touch others. Hence, this can be represented by drawing them with no blobs.
Power Supply
The presence of power supply in an electronic circuit is basically to convert high voltage AC electricity to an appropriate low voltage supply. A power supply is capable of breaking down into several blocks, where each can perform a specific function.
Cell
A cell is used to offer electric supply to the circuit.
Battery
A battery is more than a cell and performs the same purpose. Moreover, the smaller terminal acts as the negative, whereas the larger end is positive.
DC Supply
Considering a DC power supply, the current would always move in a single direction.
AC Supply
Among electric symbols, with an AC power supply, the current would move in alternating directions.
Transformer
It is used as an AC power supply that comprises of two coils. One is the primary and the other acts as the secondary. Both of these are associated on an iron core. However, there is no physical connection among the two coils. In a transformer, the mutual inductance is the prime principle which is utilized to obtain power.
Resistor
A resistor in an electric circuit behaves as a passive two-terminal component which produces electrical resistance. Further, resistors can be used to decrease current flow, manage signal levels and divide voltages.
It is to curb the amount of current which is flowing through the device.
Rheostat
The function of the rheostat is focused on controlling the flow of current with two contacts. This electric component is applicable for controlling capacitor charge rate, lamp brightness etc.
Capacitor
You can call a capacitor a component that holds the ability to store energy as electrical charge. This function is produced by the potential difference across its plates.
It is a device which is used to pile up electrical energy. A capacitor consists of two metals plates which are separated with a dielectric. Further, it is used as a filter to restrict DC signals and permit AC signals.
Variable Capacitor
A variable capacitor is used to vary capacitance using the knob. A popular type of variable capacitor can be seen in the form of trimmer capacitor, which is quite small in size.
Answer:
Battery. The symbol for a battery is shown below. ...
Variable resistor (Potentiometer) The variable resistor or potentiometer is drawn in several different ways. ...
Diode. ...
Inductor. ...
Integrated Circuit. ...
Logic Gates. ...
Operational Amplifier. ...
Switch.
Explanation:
hope its helps u