Give the operating steps of autoclave
Answers
Answer:
Operating Autoclave
• Check to be sure that the water reservoir is filled (approximately 1” from top), and if not, fill with distilled water.
• Choose appropriate cycle ( e.g. fluid, dry etc) for the material.
• Set appropriate temperature for the cycle.
• Turn the autoclave to FILL and wait until the water in the bottom of the autoclave covers the fill plate.
• Turn the autoclave to STERILIZE and load autoclave
• Close and lock door
• A steam cycle is approximately 40 minutes if the autoclave is cold and approximately 20 minutes if it is already warmed from a previous steam cycle.
• When cycle is complete, turn autoclave to VENT and remain there until pressure drops. The heat stays on during the venting and without the steam plastics will melt.
• Turn the autoclave to POWER OFF.
• Do not attempt to open the door while autoclave is operating.
• The manuals for operation of the autoclave are located on the wall behind the autoclave.