Science, asked by ishagardi1112, 4 months ago

how acid and base tested in laboratory?​

Answers

Answered by daksh1114080
0

Answer:

please Mark me as brainliest

Answered by shivajikaithi
0

Answer:

The buffering capacity of a solution is tested by adding small amounts of acid (for example, HCl) and base (for example, NaOH) and checking the pH after each addition. If the pH changes only slightly, the solution is a good buffer

Previous Question
Next Question
Similar questions
English, 2 months ago
please tell me the answer​...
Math, 2 months ago
take a point O on your notebook and draw circles of ratio 4 cm 5.3 cm and 6.2 cm each having the same Centre O​...
Math, 2 months ago
Solve and check : 3(x-3)=15...
Math, 4 months ago
The arithmetic mean of 20,60,and40————​...
Math, 4 months ago
(2x-3y)^2-(2x+3y)^2lets simplify...
Computer Science, 9 months ago
Suppose a and b are on same 10mbps ethernet segment and the propagation delay between two nodes is 275 bit times. Suppose a and b are on two ends of the wire and tries to send a frame at time t=0 and frames collide. Then at what time (in bits) they finish transmitting a jam signal. Assume 48 bit jam signal.
Business Studies, 9 months ago
Strategic management consists of the analysis, decisions, and actions organization undertakes in order to create and sustain competitive advantages. This definition is given by whom?
Math, 9 months ago
Sum of a series 1/1! + 2/2! + 3/3! + 4/4! ++ n/n!