Physics, asked by devham107, 1 year ago

How to make a tv remote jammer

Answers

Answered by MansiArora5
4
what is ur question bro..........

devham107: How to make a tv remote jammer
MansiArora5: jammer means
Answered by Abhishek75700
2
⚫⬛✔☛Basically it confuses the infra-red receiver in a TV. It produces a constant signal that interferes with the signal from a remote control and prevents the TV detecting a channel-change or any other command. This allows you to watch your own program without anyone changing the channel!! The circuit is adjusted to produce a 38 kHz signal. The IR diode is called an Infra-red transmitting Diode or IR emitter diode to distinguish it from a receiving diode, called an IR receiver or IR receiving diode. 
⚫☛✔The circuit parts: 
1. Small circuit board 
2. (1) 10k variable resistor 
3. (1) 555 Timer 
4. (4) resistors. 470ohm, 1k, 560ohm 
5. (2) high speed switching diodes 1N4148 
6. (1) transistor - BC557 
7. (2) Infrared LED's 
8. (2) 10nf capacitors 
9. (1) 9 volt battery 
☛⚫✔hot glued the circuit inside the remote control. I also had to remove 2 posts to make room for the 9 volt battery. Tape down the LED's near the existing LED. I used the existing switch on the remote and wired my 9 volt battery to it.
⚫✔⬛You may have to tinker with the 10k pot to get the frequency right for the device you are targeting. Adjust the pot while the remote is 'on' and test it with the original remote until the jammer confuses the device. Now, just pull out the remote whenever you need to take control of your device and no one will have any idea what's going on
⬛⚫☛✔To confuse the receiver, this jammer sends out a steady stream of binary code (1's an 0's) at the same frequency, but contains no information to decode. The receiver basically sits there and does not respond at all and the real information cannot get through to it as long as the jammer is on. Voila! You've 'jammed' your TV remote!HOPE MY ANSWER HELPS U ...☛☺☺✌✔
Similar questions