How to make an paper airplane and an paper car
Answers
Paper plane..
Fold the paper in half vertically.
Unfold the paper and fold each of the top corners into the center line.
Fold the peak toward you and 3/4” from the bottom of the paper.
Fold both top corners into the center line.
Fold the remaining tip over the two flaps at the center line to lock them in place.
Fold the plane in half away from you.
Fold the wings down 1” from the bottom of the plane.
Fold up the sides of each wing 1/2” tall.
Cut two small slits at the back of each wing. Fold up the tabs.
Add double stick tape to the inside of the body. The finished plane should look like this.
Paper car
Make a crease in the middle of the origami paper. Fold the paper in half, widthwise. Run your fingernail along the fold to make a crease, then unfold the paper. Fold the top and bottom edges of the paper by 1/3. Fold the top edge of the paper down by 1/3. Next, fold the bottom edge of the paper up by 1/3. You should now have 3, equal-sized sections on your paper.[2]
For the rest of the tutorial, the folded top and bottom edges will be called the "top" and "bottom" flaps.
The top and bottom third of your paper will be colored, while the middle will be white. If you are making a white car, then the middle part will be colored.
Fold the corner of the top flap up until it goes past the folded edge. Go back to your top flap. Fold the bottom-right corner upwards until it goes past the top, folded edge. The left point of the corner should be about 1/3 of the way across the flap.[3]
Keep the top flap folded down for this step. Don't unfold it!
Fold the other corners in a similar way. Fold the bottom-left corner on the top flap upwards. Next, fold the top 2 corners of the bottom flap down. Each folded corner should be 1/3 the length of your flaps.
You are essentially doing the same process for the bottom flap as you did for the top. If you need to, rotate the paper so that the bottom flap is along the top.
Fold the tips of the corners to make them more wheel-like. The corners that you just folded will make the wheels. Unfortunately, they are pointy, which is not very wheel-like. To fix this, fold down the tips of the corners to flatten them.[4]
If you want to, you can "cheat" by cutting the corners into semi-circles. This is stepping away from origami, however.
Fold the whole paper in half along the first crease. This completes the body of your car, so make sure that the color you want is on the outside. Be sure to run your fingernail back and forth across the top crease to sharpen it.[5]
You while have a bottom fold, just above the wheels. If you want to, run your fingernail across it (on both sides of the car) to make it neater.
first take paper in hand fold it and both side fold half and make front like noke and give little air in