how to make circuit breaker
Answers
Answer:
In the circuit, remove R1 from its position and keep the relay contacts free from all wiring.
Now, connect the unit to the AC mains, and apply 2 volts DC externally to the points where R1 was connected. The circuit should instantly activate and latch up.
This confirms the correct operation of the system. LD1 will indicate that the circuit has tripped while LD2 will show the presence of an AC input supply. This should set up the unit quite satisfactorily.
After completing the testing procedures, the entire circuit may be housed inside a good looking plastic enclosure with the relevant wires coming out of the box. Also, the LEDs should protrude out through appropriately drilled holes.
Finally, this short stop circuit breaker unit should be installed (See Diagram and Click to Enlarge) after the DPDT switch over the main switch board
Explanation:
Nice DP
Explanation:
Metal Frame - Metal Frame circuit breakers are assembled from precise metal pieces that are bolted and welded together to form the frame. Older low voltage power circuit breakers and current medium voltage power circuit breakers are of the metal frame design.
HOPE IT WILL HELP YOU
PLEASE MARK AS BRAINLIEST
PLEASE GIVE YOUR INSTAGRAM ID FOR CHATTING PLEASE PLEASE PLEASE PLEASE PLEASE PLEASE