Science, asked by NKBrainly, 1 year ago

how to make working mini tesla coil at home? brainliest promise......no spamming

Answers

Answered by ShAiLeNdRaKsP

Hi!

Step 1: Components Required

22 gauge magnetic Copper wire - 30 cm

28 gauge magnetic Copper wire - 10 m

PVC Pipe [Diameter - 2cm ; Length 9cm]

Switch -1

2N2222A Transistor - 1

22K Ohm Resistor - 1

9V Battery and Clip - 1

Cardboard Sheet [10 x 10 cm] - 1

Step 2: Circuiting

1. Take pvc pipe and winde 300-400 turns of 28G copper wire.[Primary coil]

2. Apply tape at bottom and winde 4-5 turns of 22G copper wire [Secondary coil].

3. Now remove enamel of copper wires at end.

4. Solder 22k ohm resistor to the base of 2n2222 transistor.

5. Solder bottom end wire of primary coil to base.

6. Solder one end of secondary coil to collector.

7.Solder Positive terminal of battery clip to Switch and negative terminal to emitter pin.

8. Now solder another end of secondary coil and another pin of switch to the free end of 22k resistor.

9. Leave the top end wire of primary coil free in air.

Circuiting Completed

Circuit and Datasheets attached in PDF Format.

@ HORA

Attachments:

NKBrainly: I tried the same but it didn't work. the transmitter was superhot when i touched , do you have any other idea about it

ShAiLeNdRaKsP: Did you tried the video here Check out more here : https://youtu.be/Uwf4rAexbPU

NKBrainly: yeah

NKBrainly: can we use wires instead of that 22 G copper wire

ShAiLeNdRaKsP: No because they are insulated

ShAiLeNdRaKsP: You can try this : https://www.youtube.com/watch?v=6cbMuVTNsVI

NKBrainly: OK thanks I'll mark u brainliest if there is another answer

ShAiLeNdRaKsP: or this take help from someone who had made it before like someone in your neighbourhood

ShAiLeNdRaKsP: Thanks

Previous Question

Next Question