Question

How to prepare MASTER/SLAVE disk using jumper and bus connection and connect all drivers to motherboard

Answer 1

Answer:

You simply set the jumper to Cable Select on both drives and depending on where you connected them to the cable the computer would know which is Master and which is Slave. If you are going to use Cable Select you need a special 40 conductor IDE cable that would determine master and slave connections.

Answer 2

Answer:

Answer: You simply set the jumper to Cable Select on both drives and depending on where you connected them to the cable the computer would know which is Master and which is Slave. If you are going to use Cable Select you need a special 40 conductor IDE cable that would determine master and slave connections.