Math, asked by aara388591, 10 months ago

. Mohit enlarges a photograph that is 8 cm wide
and 6 cm high. If the height of the enlarged
photograph is 24 cm, its width is

Answers

Answered by adityakushwaha731

6

Answer:

32

Step-by-step explanation:

since height is enlarged by 4x soo width will also enlarge by 4x soo

8*4 =32

Previous Question

Next Question

Similar questions

Science, 5 months ago

what is fire colour and what is fire formula...

Physics, 5 months ago

a car moves with a speed of 140 km/hr for 15 minutes and 280 km/h for the next 15 mins. find the total distance covered by the car. please answer this question properly fast. i will mark brainliest for mooooost appropriate answer.

Math, 5 months ago

1. Adjacent angles 2. Equal Complementary angles 3. Angles Obtuse angles 4. Unequal Complementary angles 5. Angles that are Acute angles...

English, 10 months ago

A speech delivered without preparation?"one word substitution"...

English, 10 months ago

Brainly ke maharathiyon.. Kardo iss gareeb ki madad. 1. The only piece that can jump over another piece in the game of chess. 2. The only piece that cannot defeat a king. Note-Abbe sahi answer karna...

Computer Science, 1 year ago

The Acme Corporation is implementing dial-up services to enable remote-office employees to connect to the local network. The company uses multiple routed protocols, needs authentication of users connecting to the network, and since some calls will be long distance, needs callback support. Which of the following protocols is the best choice for these remote services? A.802.1 B.Frame Relay...

Computer Science, 1 year ago

You need to configure a router for a Frame Relay connection to a non-Cisco router. Which of the following commands will prepare the WAN interface of the router for this connection? A.Router(config-if)# encapsulation frame-relay q933a B.Router(config-if)# encapsulation frame-relay ansi C.Router(config-if)# encapsulation frame-relay ietf D.Router(config-if)# encapsulation frame-relay cisco...

Computer Science, 1 year ago

If routers in a single area are configured with the same priority value, what value does a router use for the OSPF Router ID in the absence of a loopback interface? A.The lowest IP address of any physical interface B.The highest IP address of any physical interface C.The lowest IP address of any logical interface D.The highest IP address of any logical interface...