Question

note on earthquake in English note on note on earthquake

Answer 1

earthquake in 1906

An earthquake (or quake or tremor) is the shaking of the surface of the Earth. Earthquakes can be extremely violent or so slight that they only register on instruments. They are caused by sudden movements of the Earth's tectonic plates.

The study of earthquakes is called seismology.[1] Earthquakes are usually quite brief, but may repeat. The sudden release of tension in the tectonic plates sends waves of energy that travel through the Earth. Seismology studies the cause, frequency, type and size of earthquakes.


There are large earthquakes and smallearthquakes. Large earthquakes can take down buildings and cause death and injury. Earthquakes are measured using observations from seismometers. The magnitude of an earthquake, and the intensity of shaking, is usually reported on the Richter scale. The Richter Scale was invented by Charles Francis Richter in 1935. On the scale, 2 is scarcely noticeable, and magnitude 5 (or more) causes damage over a wide area.



Hope you will make my answer brainliest please please please.

Answer 2

Tectonic earthquakes occur anywhere in the earth where there is sufficient stored elastic strain energy to drive fracture propagation along a fault plane. The sides of a fault move past each other smoothly and aseismically only if there are no irregularities or asperities along the fault surface that increase the frictional resistance. Most fault surfaces do have such asperities and this leads to a form of stick-slip behavior. Once the fault has locked, continued relative motion between the plates leads to increasing stress and therefore, stored strain energy in the volume around the fault surface. This continues until the stress has risen sufficiently to break through the asperity, suddenly allowing sliding over the locked portion of the fault, releasing the stored energy.[1] This energy is released as a combination of radiated elastic strain seismic waves, frictional heating of the fault surface, and cracking of the rock, thus causing an earthquake. This process of gradual build-up of strain and stress punctuated by occasional sudden earthquake failure is referred to as the elastic-rebound theory. It is estimated that only 10 percent or less of an earthquake's total energy is radiated as seismic energy. Most of the earthquake's energy is used to power the earthquake fracture growth or is converted into heat generated by friction. Therefore, earthquakes lower the Earth's available elastic potential energy and raise its temperature, though these changes are negligible compared to the conductive and convective flow of heat out from the Earth's deep interior.