Question

Simulation :

a) Replace the lamp by a resistance between 100Ω and 10000Ω

b) Using Orcad , simulate the Circuit for three different values for the sensor resistor (the selected values of the resistance must cover the two states of the lamp.

c) Plot the waveform of the capacitor voltage and calculate the ripple factor for the three simulations .

d) Indicate the settings of the center tapped transformer .

e) Depending on the current through the lamp determine the state of the lamp (on or off) in the three simulations.​

Answer 1

Answer:

X-axis=(5,0)   Y-axis =(0,5)

Comparing with (n,0)  and  (0,m)

n=5  and m=5

∴m+n=5+5=10