Science, asked by ramabairama24, 6 months ago

the closeness of the measured value to the original value is------

Answers

Answered by daksheshdoshi123

4

Answer:

Accuracy refers to the closeness of a measured value to a standard or known value.

Answered by sivamanoj15

3

Answer:

Accuracy refers to the closeness of a measured value to a standard or known value.

Previous Question

Next Question

Similar questions

Math, 3 months ago

2. Find the base of a right angle of area 42 cm² and height 6 ...

Math, 3 months ago

whose elements are Construct a 3x3 matrix A = [ang] aj = (-1) city) by aij= (-1)...

Hindi, 3 months ago

रात बीतने पर क्या क्या परिवर्तन होते हैं...

Science, 6 months ago

which one of the following limit for tablets is acceptable to lose weight during friability studies a)less than 0.5toh1% b)more than2% c)more than5% d)none of them...

Accountancy, 6 months ago

Followling is the balance sheet of X Ltd. Particulars Note No. 31st March, 2020 (₹) 31st March, 2019 (₹) I. Equity and Liabilities 1. Share Holders Funds (a) Share Capital (b) Reserves and Surplus 2. Non Current Liabilities (8 % Bank Loan) 3. Current Liabilities (a) Trade Payables (b) Short-term Provisions 1 2 3 6,00,000 1,28,000 1,00,000 22,000 50,000...

Science, 10 months ago

When parallel resistors are of three different values, the potential difference across its terminals is [CCE 2015] (a) greatest across smallest resistance (b) greatest across largest resistance (c) equal across each resistance (d) least across the smallest resistance...

Science, 10 months ago

A milliammeter had graduations marked 0, 100, 200, 300, 400 and 500 The space between 0 mark and 100 mark is divided into 20 divisions If the pointer of the milliammeter is indicating the seventh graduation after 300 mark, the current flowing in the circuit is (a) 335 mA (b) 330 mA (c) 331mA (d) 340 mA...

Science, 10 months ago

In an experiment on studying the dependence of the current I flowing through a given resistor on the potential difference V applied across it, a student has to change the value of the current For doing this, he should change the (a) number of cells used (b) resistor itself (c) ammeter used in the circuit (d) Voltmeter used in the circuit...