Question

The values of CS1 and CS2 should be ------------- to enable the RAM Chip.

Answer 1

Explanation:

A mummy is a deceased human or an animal whose skin and organs have been preserved by either intentional or accidental exposure to chemicals, extreme cold, very low humidity, or lack of air, so that the recovered body does not decay further if kept in cool and dry conditions. Some authorities restrict the use of the term to bodies deliberately embalmed with chemicals, but the use of the word to cover accidentally desiccated bodies goes back to at least 1615 AD (See the section Etymology and meaning).

Mummies of humans and animals have been found on every continent,[1] both as a result of natural preservation through unusual conditions, and as cultural artifacts. Over one million animal mummies have been found in Egypt, many of which are cats.[2] Many of the Egyptian animal mummies are sacred ibis, and radiocarbon dating suggests the Egyptian Ibis mummies that have been analyzed were from time frame that falls between approximately 450 and 250 BC.[3]

In addition to the well-known mummies of ancient Egypt, deliberate mummification was a feature of several ancient cultures in areas of America and Asia with very dry climates. The Spirit Cave mummies of Fallon, Nevada in North America were accurately dated at more than 9,400 years old. Before this discovery, the oldest known deliberate mummy was a child, one of the Chinchorro mummies found in the Camarones Valley, Chile, which dates around 5050 BC.[4] The oldest known naturally mummified human corpse is a severed head dated as 6,000 years old, found in 1936 AD at the site named Inca Cueva No. 4 in South America.[5]

Answer 2

Answer:  To turn on the RAM chip, CS1 and CS2 must both be set to 1.

Explanation:

• If a RAM chip has one or more control inputs that only select it when necessary, it will communicate with the CPU more effectively.
• A bidirectional data bus, which enables data flow from memory to CPU during reading operations or from CPU to memory during writes, is another typical characteristic.
• Three-state buffers can be used to build a bidirectional bus.
• One of three possible states for a three-state buffer output is either a signal corresponding to logic 1, a signal equivalent to logic 0, or a high-impedance state.
• Normal digital signals are logic 1 and logic 0.
• As a result of the high impedance state's behavior, which resembles an open circuit, the output has no signal and no logical import.

#SPJ3

https://brainly.in/question/53803467