what is injection molding cycle process
Answers
Injection moulding involves a high pressure injection of a polymer into a mould where it is shaped. The whole injection moulding process usual lasts from 2 seconds to 2 minutes. There are four stages in the cycle. These stages are the clamping, injection, cooling and ejection stages.
PLZ MARK ME AS BRAINLIEST!!!!!!!!!!!!!!
Answer:
Injection moulding involves a high pressure injection of a polymer into a mould where it is shaped. The individual parts of this process are very short. The whole injection moulding process usual lasts from 2 seconds to 2 minutes. There are four stages in the cycle. These stages are the clamping, injection, cooling and ejection stages.
Clamping
Before the mould is injected with material, both halves of the mould have to be closed. They are closed by a clamping unit. Both halves are then attached to injection moulding machine and one half can slide. Material is then injected as the clamping unit pushes the halves together and both halves are held tightly while material is injected. Larger machines (machines with more clamping power) take longer to close and clamp the mould.
Injection
Plastic pellets are fed by means of a hopper into the injection moulding machine. These pellets move towards the mould by the injection unit. The heat surrounding the barrel and the pressure serve to melt the pellets. The volume of material injected is called the ‘shot’. This injection time finished when 95%-99% or the mould is filled. It is hard to calculate exactly the injection time because the flow of the plastic is always changing and dynamic. Injection time can be estimated by other factors such as injection pressure,power and shot volume. The injection pressure can range from 35-140 MPa. The rate of injection and the pressure which can be reached are determined and controlled by the hydraulic system in the machine.
Cooling
The cooling process involves the plastic inside the mould beginning to cool after it makes contact with the interior mould. As the plastic cools when it hardens it will take the desired shape. The part may shrink slightly during cooling. Only when the cooling period has elapsed can the mould be opened.
It is from the wall thickness of the part and the thermodynamic properties of the plastic that the cooling time can be estimated.
Ejection
The last stage is ejection from the machine. This is done with an ejection system. When the mould opens the part is pushed out, Force must be used because the part shrinks and sticks to the mould. The mould can be shut again after ejection and another shot can be injected for the process to begin again.
Mould design is a key factor in determining the quality of the finished product. The strength, durability, shape and size all rely on the type of mould that is used. The mould must be sturdy and be able to withstand the pressures involved during the injection process. The polymer must also be able to flow properly along the mould. The mould must also be carefully designed to allow heat transfer to control the cooling process.
This is a complex process and it takes highly trained individuals to oversee the entire process. At APL while it is important to keep output levels high safety is also a primary concern.
At Automatic Plastics we do our very best to offer quality plastic parts across a wide range of industries using this process. Contact APL regarding your injection moulding needs we’re very happy to talk with you regarding your requirements and can offer you a highly competitive quote.
