Physics, asked by ramyasri3253, 1 year ago

where is the resistive load placed in a directional coupler

Answers

Answered by smtgupta

1

Answer : The device is normally used to split the input signal and distributed power. The device couples part of the transmission power by a specific factor through one port. Directional couplers are used in a wide range of applications which involve measurement, power monitoring and other utilities.

Previous Question

Next Question

Similar questions

Science, 6 months ago

tiny pores that allow the plants to breathe answer this question pl...

English, 6 months ago

In any data transmission mode when the sender is happy Can send data? A) Asynchronous transmission b) Synchronous transmission C) Isocronus transmission d) Parallel transmission...

Math, 6 months ago

There is some profit when an article is sold for Rs 720. However when the same article is sold for Rs 420, there is some loss. If the quantum of loss is two times the quantum of profit, then the cost price of the article is (A) Rs. 620 (B) Rs. 700 (C) Rs. 520 (D) Rs. 600 ...

Biology, 1 year ago

where can stem cells be obtained be from a placenta...

Biology, 1 year ago

When looking for suitable flat feet shoes take into consideration the range to be run, surface type and background of injuries.

Science, 1 year ago

A person uses a lens of power -2.0D for correcting his distant vision and for correcting his near vision he used lens of power +2.0D . Calculate the focal lenght of lenses required to correct these defects.

Physics, 1 year ago

‘n’ moles of an ideal gas undergoes a process A→B as shown in the figure. The maximum temperature of the gas during the process will be :...

Physics, 1 year ago

Resistence of a metal wire of length 1m is 26 at 20C .If thr dimeter of the wire is 0.3mm, what will be the resistivity of the metal at the temperature? Using table 12.2, predict the material of th wire.