which one of the following better for vinegar production is it packed bed bioreactor or bubble column bioreactor?
Answers
Explanation:
the development of a continuous acetic acid fermentation process for the production of wine vinegar in bubble column reactors of up to 60 l capacity. To determine appropriate fermentation conditions a study of the influence of residual ethanol concentration, inlet flow rate and aeration was carried out using a 6-l laboratory reactor, white table wine as fermentation medium, a temperature of 30 C and an air flow rate of 0.125 min-1 (vvm). The concentration of acetic acid obtained in the continuous wine vinegar production ranged from 91 g/l at 28.6 ml/h to 28 g/l at 154.1 ml/h by increasing the inlet flow rate. As expected, the biomass decreased as well, from 208 mg/l to 106 mg/l. The maximum acetification rate was observed in the range 85-110 ml/h, corresponding to a value of about 1.1 g/l/h. A further increase in the flow rate produced a slight decrease in the acetification rate. Best yields, between 94.5 and 94.7%, were obtained in the flow rate range of 60-75 ml/h. The acetification rate was improved only by about 10% by increasing the aeration from 0.125 to 0.250 min-1. The continuous wine vinegar production was scaled up from the laboratory fermentor to a 60-l pilot acetator. During the steady state (residential time >6), with an inlet flow rate of 950 ml/h, temperature of 30 C and aeration of 0.250 min-1, the following parameters were obtained: acetic acid concentration 72 g/l, overall productivity 1.41 g/l/h and yield 94.2%.