☆ Write a program for
LED on and OFF
Answers
Answer:
Some of the suggestive measures the Indian government can take to increase employment are:
Improve quality of education. ...
Invest in technology. ...
Invest in physical infrastructure. ...
Structural reforms by lower taxes. ...
Lower interest rates.
YOU WILL NEED
.An LED (any color works fine)
An LED (any color works fine)A 220 Ohm Resistor
.An alligator clip (not essential but makes the circuit easier)
.Fourteen small and smooth rocks from the a western pacific island (not essential but adds an esoteric feel)
NOTE: On most Arduino boards there is an LED soldered right by pin 13 – it is actually connected to pin 13 – so if you do not have an LED laying around (or a resistor for that matter), you can use the board mounted LED – it will blink with the same sketch.
NOTE: On most Arduino boards there is an LED soldered right by pin 13 – it is actually connected to pin 13 – so if you do not have an LED laying around (or a resistor for that matter), you can use the board mounted LED – it will blink with the same sketch.STEP-BY-STEP INSTRUCTIONS
Insert the short leg of the LED into the GND pin on your Arduino (use the GND pin closest to pin 13).
.Connect the 220 Ohm resistor to pin 13 on the Arduino. It doesn’t matter which way you connect the resistor.
.Use the alligator clip to connect the long leg of the LED to the other leg of the resistor. If you do not have an alligator clip, twist the two leads together as best you can to get a steady electrical connection.
.Plug the Arduino board into your computer with a USB cable.
Open up the Arduino IDE.
Open the sketch for this section.
.Click the Verify button on the top left. It should turn orange and then back to blue.
Click the Upload button. It will also turn orange and then blue once the sketch has finished uploading to your Arduino board.
.Now monitor the Arduino board – the LED should be blinking.
PLEASE MARK ME AS BRAINLIEST PLEASE.......
HAVE A GOOD DAY TO YOU❤️❤️❤️❤️