Science, asked by aesh2000, 2 months ago

write the CNC lathe program for the guide pillar​

Answers

Answered by Anonymous
2

Explanation:

Step 1 – Eliminate Assumptions. Because of modal commands (discussed in Chapter 2), it is possible that the machine may have settings in a different state than the programmer may expect. ...

Step 2 – Establish The Coordinate System. ...

Step 3 – Program Toolpaths. ...

Step 4 – End Safely.

Previous Question
Next Question
Similar questions
Physics, 1 month ago
give examples for good solid and liquid conductors...
Physics, 1 month ago
24) There are four point masses m each on the corners of a square of side length 1 about one of its diagonals, the moment of inertia of the system is 1 0 ! a) 2 ml2 c) 4 m2 b) ml2 d) 6 ml​...
Political Science, 1 month ago
27. Which among following statements is not a feature of democratic government? a. Government functions within the limits set by the constitution. b. Adult citizens have one vote one value. c. Elected leaders act only by consulting with military officials.​
Math, 2 months ago
fimd the factors of following trinomials (x+3) (x+2)​...
Math, 2 months ago
Find the sruface area of a cylinder if its radium is 25cm and height is 45cm​...
Math, 9 months ago
10 to the power-5 into 100000 equals to 100 to the power m.Find the value of m ​...
Physics, 9 months ago
America k kisi bhi ek satellite k coordinaes bta do please.​
Math, 9 months ago
square root 12 root 5 + 2 root 55 is equal to​...