Science, asked by RomiGill, 1 year ago

how to prepare electric current and its material

Answers

Answered by ChaEunSang
1
The wires will be conducting your electric current from the batteries to the light bulb. The easiest way to attach the wires is to use electrical tape. Attach the end of one wire to one side of the battery, making sure that the wire maintains contact with the metal of the battery. Repeat with the other wire on the other side of the battery.To build a simple circuit, you will need a power source, two insulated wires, a light bulb, and a light bulb holder. A power source can be any type of battery or battery pack. The rest of the materials can be found at your local hardware store.When choosing a light bulb, keep in mind the amount of power your battery emits.To simplify the wire attachment process, use a battery snap with wires pre-attached and a nine volt battery or battery pack.In order for your circuit to work properly, the wires need to be totally exposed so you must strip the ends. Using wire strippers, remove about an inch of the insulation from the ends of each wire.If you don’t have wire strippers, you can carefully use scissors to cut off the insulation.Be careful not to cut all the way through the wire Depending on the type of batteries you are using, you may be able to skip this step. If you are using multiple batteries, you will need a power pack to hold the batteries. Push each battery in by the side taking care to put the positive and negative ends in the correct orientation. Screw the light bulb into its holder until it is tight. If your circuit is hooked up properly, the bulb should light up when fully screwed into its socket.check the circit well then start it.
Similar questions