In msp430g2303 for automatic baud rate detection, a data frame is preceded by a synchronization sequence that consists of a break and a synch field.What should be the value of ucmodex in uart mode in msp430g2303 which made automatic baud rate detection
Answers
Answer:
Explanation:
Automatic baud rate detection (ABR, autobaud) refers to the process by which a receiving device (such as a modem) determines the speed, code level, start bit, and stop bits of incoming data by examining the first character, usually a preselected sign-on character (syncword) on a UART connection. ABR allows the receiving device to accept data from a variety of transmitting devices operating at different speeds without needing to establish data rates in advance.
During the autobaud process, the baud rate of received character stream is determined by examining the received pattern and its timing, and the length of a start bit. These type of baud rate detection mechanism are supported by many hardware chips including processors such as MPC8280, MPC8360, and so on.
When start bit length is used to determine the baud rate, it requires that character should be odd since UART sends LSB bit first. Often symbols 'a' or 'A' (0x61 or 0x41) are used. For example, the MPC8270 SCC try to detect length of UART start bit for autobaud.
Most of modems seen in market currently support autobaud. Before receiving any input data, most modem use a default baud rate 9600 for output. For example, the following modems have been verified for autobaud and default output baud rate 9600.
USRobotics USR5686G 56K Serial Controller Fax modem
Hayes V92 External modem
microcom DeskPorte 28.8P
The baud rate of modems are adjusted automatically after receiving input data by autobaud process.
may be it's helpful for you