Question

Internet Protocol version 6 (Pro) the most recent version of the Intemet Protocol (P),
the communications protocol that provides an identification and location system for computers on
networks and routes traffic across the Internet. With the rapid growth of the Internet after
commercialization in the 1990s, it became evident that for more addresses would be needed to connect
devices than the IPv4 address space had available. By 1998, the Internet Engineering Task Force (ITF)
had formalized the successor protocol. Pv6 uses a 128-bit address, theoretically allowing 2128, or
approximately 3.4x1038addresses. The total number of possible Pv6 addresses is more
than 7.9x1028 times as many as IPv4, which uses 32-bit addresses. Therefore, the goal is to implemeat
ipv6 addressing instead of ipv4 addressing in our networks.
CEP Statement:
Design an IPvó based WAN (wide area network) using available hardware in the lab (Cisco Router,
switches, access points, hutt).
In the planning stage, select the network devices and justify your selection. In the implementation stage
specify the parameters of each device.
Implement ipv6 addressing. Connect minimum of three 3 end devices. All devices and active ports shall
ping each other. You should give proper reasoning of protocols and basic configurations followed
in the network.
Course
WK
PLO (WA)
Bloom's
Learning Level
WK3. WK4
3 (Design)
Computer
Communication
and Networks
TVPI. WP2,
WP3, VP4. EP2
Deliverables:
Complete design of the network topology
Configuration cornmands
Project report addressing all requirements
Pre Requisite:
To carry out this complex engineering problem you should have the knowledge and understanding of
Networking devices
Routine protocols
IP addressing and subnetting​

Answer 1

Answer:

he has to be on our way home from the bottom and u uwiwiu he was was was like ur up I don't kuh job JDMJ uchchastareey cucumber up