Е,
Learning Task 3: Answer the puzzle. Use the table below as your guide. Write
your answers in sheet of paper.
1
3
2
10
4
9
5
00
6
Across
Down
1. sudden slip on a fault
2. happens when two plates rub
against each other as they move in
opposite directions
3. 5. block above the fault has moved
downward relative to the block below
6. causes the rocks to push or squeeze
against one another
8. fault on which the two blocks slide
past one another
9. force between the two sides of a fault
that keeps it from moving
3. fault in which the upper block,
above the fault plane, moves up
and over the lower block
4. forces the rocks to pull apart
7. zone of fractures between two
blocks of rock
10. When stress is applied to all sides
of the crust
Answers
Answer:
Explanation:
siento No como
Step-by-step explanation
hai nas estas day si x =0 latia fal iwj seiento
Answer:
1. Earthquake
2. Transform fault boundary is formed
3., 5. Normal Faulting
4. Tensional stresses
6. Compression
7. Fault
8. Strike-slip fault
9. Friction
10. Confining Stress
Explanation:
1. Earthquake
The cause of strike-slip fault earthquakes is due to the movement of the two plates against one another and the release of built up strain. As the larger plates are pushed or pulled in different directions they build up strain against the adjacent plate until it finally fails.
However, larger movements along a fault result in a tremendous release of energy. This quick release of energy is known as an earthquake. An earthquake is a sudden slip along a fault.
2. Transform fault boundary is formed
When oceanic or continental plates slide past each other in opposite directions, or move in the same direction but at different speeds, a transform fault boundary is formed. No new crust is created or subducted, and no volcanoes form, but earthquakes occur along the fault.
3., 5. Normal Faulting
Where the crust is being pulled apart, normal faulting occurs, in which the overlying (hanging-wall) block moves down with respect to the lower (foot wall) block.
4. Tensional stresses
Tensional stresses cause a rock to elongate, or pull apart. Shear stresses causes rocks to slip past each other.
6. Compression
Stress which causes rock to squeeze or push against other rock. Tension: Stress which occurs when rock pulls apart or gets longer. Shear Stress: Stress which occurs when tectonic plates move past each other causing rock to twist or change shape.
7. Fault
A fault is a fracture or zone of fractures between two blocks of rock. Faults allow the blocks to move relative to each other. This movement may occur rapidly, in the form of an earthquake - or may occur slowly, in the form of creep.
8. Strike-slip fault
A fault on which the two blocks slide past one another.
9. Friction
The tectonic plates are always slowly moving, but they get stuck at their edges due to friction. When the stress on the edge overcomes the friction, there is an earthquake that releases energy in waves that travel through the earth's crust and cause the shaking that we feel.
10. Confining Stress
When stress is applied to all sides of the crust, confining stress occurs. When this happens, the crust compacts, which makes it look smaller. If the stress is too much for the crust to handle, the crust can fracture from the inside. This causes the crust weight to decrease but the crust shape remains the same.
For more similar reference:
https://brainly.in/question/30696113
https://brainly.in/question/20569863
#SPJ3