Environmental Sciences, asked by hemalathaauma5569, 1 year ago

Low permeability of moulding sand leads to what defect

Answers

Answered by 987sumeetraj

The lower permeability is caused by finer grain size of the sand, high percentage of clay in mold mixture, and excessive moisture present in the mold. These are caused by liquid shrinkage occurring during the solidification of the casting.

Previous Question

Next Question

Similar questions

English, 6 months ago

2 Has given my hear A change of mood And saved some part Of a day I had rued. 1) Whose heart is referred to in this extract? (1) Did the speaker's mood change for the better or worse? ti) How did the speaker's mood change? GV) Briefly explain what the last two lines mean ??

English, 6 months ago

plss answer fastly...........

Math, 6 months ago

If the point (-3, 4) lies on the linear equation y = 5x + 11, then find the value of a...

Environmental Sciences, 1 year ago

Difference between environmental science and sustainable development...

Physics, 1 year ago

A meter stick of mass 600mg is pivoted at one end and displaced through an angle 60 .the increase in potential energy is...

Math, 1 year ago

the angle elevation of a jet fighter from a point a on the ground is 60 degree after a flight is 15 second angle of elevation changes into 30 degree of the key is flying at a speed of 720m/hr find the constant height...

Math, 1 year ago

Find the sum which when invested at 8% per annum for 3 year becomes 70,304 rs, when the interest is compounded annually.

Math, 1 year ago

The length and breadth of a rectangular park are in the ratio 5:2.the area of rectangle is 1000cm.find the dimensions of the park...