Question

obeda made an electrie circuit using a cell holder shown in Fig 14.4.
a switch and a bulb. When she put the switch in the ON position, the
bulb did not glow. Help Zubeda in identifying the possible defects in the
circuit​

Answer 1

Answer:

Explanation:

Figures to send Karo!

Answer 2

Answer:

One of the reasons may be that the rubber band used in the cell holder may not be tight enough to keep the two cells in contact with each other. If the cells are not in proper contact with each other, then the circuit will not be complete and current will not flow through the circuit. Hence, the bulb will not glow.

The other reason may be that the two cells are not connected properly. The negative terminal of one cell must be connected to the positive terminal of the other cell.