Question

Router>enable
Router#config t
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#int s3/0
Router(config-if)#ip addr 200.100.1.66 255.255.255.224
Router(config-if)#no shut
%LINK-5-CHANGED: Interface Serial3/0, changed state to up
Router(config-if)#exit
%LINEPROTO-5-UPDOWN: Line protocol on Interface Serial3/0, changed state to up
Router(config)#int s2/0
Router(config-if)#ip addr 200.100.1.129 255.255.255.224
Router(config-if)#clock rate 56000
Router(config-if)#no shut
%LINK-5-CHANGED: Interface Serial2/0, changed state to down
Router(config-if)#exit
Router(config)#int f0/0
Router(config-if)#ip addr 200.100.1.98 255.255.255.224
Router(config-if)#no shut
%LINK-5-CHANGED: Interface FastEthernet0/0, changed state to up
%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/0, changed state to up
Router(config-if)#exit
Router(config)#router rip
Router(config-router)#network 200.100.1.32
Router(config-router)#network 200.100.1.64
Router(config-router)#network 200.100.1.96
Router(config-router)#network 200.100.1.128
Router(config-router)#network 200.100.1.160
Router(config-router)#exit
Router(config)#exit
Router#
%SYS-5-CONFIG_I: Configured from console by console
Router#copy running-config startup-config
Destination filename [startup-config]?
Building configuration...
[OK]
Router#exit

Answer 1

Answer:

gfhjchjvnjgnkgnogbhgvfh