Tail stock set over method of taper turning is preferred for
Answers
Answer:
Tail stock set over method of taper turning is preferred for Long slender tapers
Explanation:
Tail stock set over method of taper turning is preferred for Long slender tapers
A surface may be turned in a lathe if the tool point is not fed parallel but at, a certain angle.
Taper Turning by Off Setting the Tailstock;
Taper can be machined on a job that can be turned between centres by setting over the tailstock. The method of setting over the tailstock. In this method the axis of the job rotates with an angle to machine bed axis and the tool moves parallel to the machine bed. Under this method the tailstock is off set on the basis the value of, which is in mm or inches instead of degrees. If the dead centre is set over in the opposite direction it will turn a taper its larger diameter on the side of the tailstock.