What are the objectives of a well test? Explain in detail.
Answers
Well test (oil and gas) ... The test will also provide information about the state of the particular well used to collect data.
Flow test
A Flow test is an operation on a well designed to demonstrate the existence of moveable petroleum in a reservoir by establishing flow to the surface and/or to provide an indication of the potential productivity of that reservoir. Some flow tests, such as drill stem tests (DSTs), are performed in the open hole. A DST is used to obtain reservoir fluid samples, static bottomhole pressure measurements, indications of productivity and short-term flow and pressure buildup tests to estimate permeability and damage extent. Other flow tests, such as single-point tests and multi-point tests, are performed after the well has been cased. Single-point tests typically involve a measurement or estimate of initial or average reservoir pressure and a flow rate and flowing bottomhole pressure measurement. Multi-point tests are used to establish gas well deliverability and absolute open flow potential
RFT
To check pressure equilibrium and thus homogeneity wells can be tested using wireline-conveyed tools, either in casing or open-hole. These tools include RFT, MDT, etc. and are typically run to the desired depth before actuating levers or other devices seal them against the side of the wellbore.
Drill-Stem test
In newly developed reservoirs or high-risk developments it may be worthwhile to test the well before completing it or installing full production facilities. This is usually done with a drilling rig on-site, and the string through which the well is produced is manipulated by the drilling rig.
Drawdown test
A drawdown test is one in which the rate is held approximately constant while the well pressure is measured. Shut in the well till pressure reaches static level and then flowing the well at a constant rate ,q & measuring Pwf.
Advantages
Suitable in new wells. With No need to lose production, reservoir size can be determined.
Disadvantages
Difficult to maintain constant production rate. Long shut in so that Pi is achieved is required.
Mulitrate tests
Accounts for variable rate history and applications.
Rate variations
kh product, Pr
Boundary configurations
Skin
FE
PI
Advantages
No problems with variable flow rate, no loss of production, and reduced wellbore storage.
Disadvantages
Rate fluctuations are difficult to measure on a continuous basis.
Production test
A production test is just like a drawdown test, except that it is generally run for a longer period of time.
Buildup test
This is the most preferred well testing technique. The well is first produced at a constant rate till pressure is stabilized and then the well is shut in. Pressure is recorded as a function of time.
Advantages
Precise control of rate and P* can be determined.
Disadvantages
Loss of production due to shut in.
Banker’s Test
This is a productivity test to demonstrate that adequate rates can be obtained from the well.
Interference test
This test is designed to give large-scale reservoir property trends which can give improved estimates of directional permeability and reservoir storativity.