Geography, asked by alamghdec, 10 months ago

write a introduction of internal memory and external memory of 80 words in total​

Answers

Answered by nehabeauty786
4

Answer:

Explanation:

Internal memory is normally associated with RAM (Random Access Memory) and is also known as main memory. ... It takes the form of magnetic disks and external drives which carry much higher memory capacities but input/output access times are much slower due to its access mechanisms.

External memory, also known as secondary memory, is separate from main memory. It takes the form of magnetic disks and external drives which carry much higher memory capacities but input/output access times are much slower due to its access mechanisms.

plz mark me as brainliest .

Answered by sritejvelamala
2

Answer:

HELLO MATE

Computer memory, device that is used to store data or programs (sequences of instructions) on a temporary or permanent basis for use in an electronic digital computer. Computers represent information in binary code, written as sequences of 0s and 1s. Each binary digit (or “bit”) may be stored by any physical system that can be in either of two stable states, to represent 0 and 1. Such a system is called bistable. This could be an on-off switch, an electrical capacitor that can store or lose a charge, a magnet with its polarity up or down, or a surface that can have a pit or not. Today capacitors and transistors, functioning as tiny electrical switches, are used for temporary storage, and either disks or tape with a magnetic coating, or plastic discs with patterns of pits are used for long-term storage.

Computer memory is divided into main (or primary) memory and auxiliary (or secondary) memory. Main memory holds instructions and data when a program is executing, while auxiliary memory holds data and programs not currently in use and provides long-term storage.

Main Memory

The earliest memory devices were electro-mechanical switches, or relays (see computers: The first computer), and electron tubes (see computers: The first stored-program machines). In the late 1940s the first stored-program computers used ultrasonic waves in tubes of mercury or charges in special electron tubes as main memory. The latter were the first random-access memory (RAM). RAM contains storage cells that can be accessed directly for read and write operations, as opposed to serial access memory, such as magnetic tape, in which each cell in sequence must be accessed till the required cell is located.

Magnetic drum memory

Magnetic drums, which had fixed read/write heads for each of many tracks on the outside surface of a rotating cylinder coated with a ferromagnetic material, were used for both main and auxiliary memory in the 1950s, although their data access was serial.

Magnetic core memory

About 1952 the first relatively cheap RAM was developed: magnetic core memory, an arrangement of tiny ferrite cores on a wire grid through which current could be directed to change individual core alignments. Because of the inherent advantage of RAM, core memory was the principal form of main memory until superseded by semiconductor memory in the late 1960s.

Explanation:

HOPE U UNDERSTAND ME VERY WELL

HOPE THIS ANSWER HELPS U A LOT

FOLLOW ME WILL FOLLOW BACK

MARK THIS ANSWER AS THE BRAINLIEST

GOOD LUCK

Similar questions