Question

write a program in Arduino IDE using C++ and upload in Edvino, intialize two variables x and y. Add x and y and save x by using Arithmetic operator and displayed on serial monitor with 5 second delay. please brainlist help me it is very important ​

Answer 1

Answer:

Run A Sketch in Arduino IDE

• Open the Arduino IDE software.
• Click File> Examples > Basics> Blink.
• Click upload. Then observe your sketch blink the onboard LED. Note: you can add a through hole LED to pin13 and ground on the Arduino UNO. The short pin is always ground. ...
• Update the code. Then upload the sketch, and watch the LED change. Tutorials.

Answer 2

mee too against mod...